Hi, I realize that the application is not running in Windows 10. We will help you. I suggest you to install the Application in Compatibility mode and check if it helps. This issue might have caused due to incompatibility issue. Install the application in compatibility mode. Compatibility mode runs the program using settings from a previous version of Windows.
Follow these steps to install the drivers in compatibility mode and check if that helps. • Find the application installer file location. • Right-click on the setup.exe file and click on ‘properties’. • Click on the ‘compatibility’ tab and check the box ‘Run this program in compatibility mode for’ and select operating system from the drop down menu and proceed with the installation.
• Once this is done, restart the computer and check if the issue persists. Refer: - suggested by Andre Da Costa. Hope this helps.
Hi, I have Creation PCut CTO 630. Im upgraded to new computer with Windows 10 and I cannot run my CTO630 on this system. On win 7 it was succesfully work. Can somebody hepl me?
If any other issues get back to us. We are glad to help you. Thank you Sachin.V Microsoft Community. Because I searched for DAYS, I will add my comment. I had the same problem with my PCut CT1200 vinyl cutter, running through a COM port in Windows 7 fine, then disappeared when I upgraded to Windows 10.
Pcut ct630 windows 7 driver, posted in general discussion i think i have a driver the followingin the manual that comes with the pcut ct. 630 it says you should set of the pcut ct 630to setup the creation pcut ct 630 using the serial connection. VINYL CUTTER DOWNLOAD LIST: Creation KingCut. CT630 & CT1200 USB Driver. CT/CA - USB TO SERIAL DRIVER(Win98 / XP / 7 - 32bit). CT/CA - USB TO SERIAL. Q: How to set up USB - Serial converter in Window 7. A: USB_setup. If you are using Flexi 7 just download the update for Flexi, and then in Flexi production manager select Creation Kingcut KCut pro B24. If Flexi 8 just in. I´m trying to install the USB interface for Creation PCUT CTO630 on my computer. I have downloaded the file from your site and have packed it up so that I have retrieved the.exe file. When I click the exe. File (CDM20802_Setup.exe), the installer window comes up and loads but then when it shuts down,.
I uninstalled the LXi VinylExpress software, and re-installed. I didn't use the driver on the CD with my old software, but had downloaded another copy so it was on my computer. I installed the downloaded driver in compatibility mode back to Windows 7, just as Sachin instructed, but wanted to add that my cutter didn't show up still, until I unplugged and re-plugged the USB from the cutter while it was on. As soon as I plugged the USB cable back in, the new COM port showed up in Device Manager, and finally I could run a test cut.
Get installation files here No password, all open source software. Ven_03EB&dev_6124 usb com port bussa program port creation CR-630 vinyl cutter installation instructions.
This pain in the arse device pissed me off for 3 days, the website for where it came from has broken download links, the instructions are for FTDI com ports - I assume this unit is a copy. These instructions should also apply to arduino based laser cutters.